Metal Craft Lifts
Metal Craft ® Boat Lifts are made entirely of quality aluminum structural components, stainless steel cables and fasteners (underwater), Pulleys on Stainless Steel Axles, and, a 15 year Limited Warranty on the aluminum components and welds.
PWC Cantilever Lifts |
|
 Model 850 |
 Model 1200 |
Vertical Boat Lifts |
|
 Model 4000 |
 Model 5000 |
Bunks & Guides |
|
| DeLuxe Bunks raise the boat higher off deep "V" cradle, are reinforced with an aluminum tube to prevent sag, and are fully adjustable. |  |
| DeLuxe Side Guides have dual board stand-on guides and are adjustable for width and height. |  |
| Standard Bunks are carpeted and adjustable up/down and side-to-side. | |
| Utility Side Guides have a single upright carpeted board and are adjustable for width and height. |  |
| Pontoon Bunks and Side Guides fully support the boat's tubes with dual carpeted adjustable bunks. The boat is easily guided into place with upright guides, adjustable for width and height, positioned inside of the tube bunks. |
|
Sunchaser Canopies |
|
| Very unique features not found in any other canopy. |  |
| Open end design - see the lake - no corners for birds to nest - doesn't capture wind - best canopy for ski boats with towers - the weight of vinyl - canopy fabric won't mildew - attaches with velcro - easy installation. | |
Electric Motor Drives |
|
| Direct Drive Model with two remotes, canopy light, keyed safety switch, manual hand crank. |  |
| Wheel Drive Model is easy to install and turns existing winch wheel. 110V (only 8 amps) or12v. |  |